HUP Shunt CODE 6275
Potain 22131 HUP 40/30 Maintenence Position
Select target of Maintenence Position
Enter password 8528
Left selector switch must be in position 3
Trolley in and mast telescopes up
Validate and move dogs in and lower jib.
Once done you must select new target as if you where going to erect.
You also must RE teach crane
Potain 22131 HUP Clear codes on Remote
You must clear on the CCS
Menu
Maintenance
Active faults
Push Twice on each fault to clear
Potain 22131 HUP Swing
Customer said crane would only swing to a certain point and Stop. Went out and check slew limiter and it looked good. Went into teach on remote and went to swing and re validated it and it worked fine after that
Potain 27148 westhervane adjustment
Potain HUP 40/30 CCS password for Remote 6275
Tried to fire up crane. Remote would not connect to crane. Had to go in and change the group to match remote. Pass is 6275
Tried 8528 and it didn’t work
Potain 28148 Jib down to check jib tip
Here is the chart for when you can jib down with different jib configurations
Potain 27148 weathervane cover
You need to put crane in weathervane in order to be able to get cover back on. Put cover on lift manual weathervane about 1” and then twist
Potain 27148 Encoder and fan on top of drive
Swing drive was getting encoder and fan error. I tried to turn the encoder off but it didn’t work. You are supposed to be able to just turn it off. I then replaced encoder and cleared errors.
Detail for Turning encoder off
Menu
Parameters
Complete list
96 System Menu
02 Pass code
Last two are 71
Back
Menu 74
Menu 12
Enter disconnected
Potain 27148 Trolley losing 3rd speed
Went to jobsite to check out trolley. They would lose 3rd speed every now and then and a lot of clicking noise in the panel.
Went to the erection aid it was changing between =0 and >30. Sensor at cats head was not communicating properly.
Went to electrical and found that both B910n and B912n need to be on. Put jumper from 44 to 40 and from 44 to 48. This made it equal zero in erection aid.
Will need to remove jumpers and fix before dismantle
