Category: Potain HUP 40/30

Tried using Crane CCS code to get into maintence mode and it remains locked.

Must use technican CCS code to get to that menu

See attached for Access rights for either Crane code for Technican Code

Access Codes Levels For New HUP

Time shows 12:00AM and date shows 1/1/00.  Fault (00024.00083) show SCM date and time incorrect.

Enter Mounting Menu (6).  Enter System Date Menu (5)  Reset date and time.

This is for older HUP’s that use 4 digit password.

After service and teach-in of a Hup 32-27 The jib was required to be folded for weathervane. Went through the book to confirm the steps were completed in order and done correctly. 

The crane would fold the jib tip but not the complete jib. A red x would appear when weathervane target was selected.

The image for the Trolley position if glanced at quickly is difficult to decern the correct trolley placement. Note: The trolley must not be in the transport position.

Trolley in, until the trolley is completely inside the first jib section. This will allow the jib to fold for weathervane.

Crane will not swing at start up, but will kick out of weathervane.  Manually lift swing brake and attempt swing again, and crane will swing normally, however will not brake normally.

Look for +20VDC at V100F, and verified.  Look for +20VDC at K600M #7 and verified.  Found no voltage at K600M #8.  Although contactor was energized, contacts were not closed.  Replace K600M.

**Note** this was specifically on a Hup 32-27 which only has 1 swing motor.  Condition may be different with 2 swing motors on Hup 40-30

While Programming the CCS for Top Zone on Submenu (66) the crane will not accept the 10 digit Activation code. And will not change from (Zone not activated) to (Zone activated). The crane doesn’t know its serial number.  You need to go to Submenu (60 Mounting then to Serial) then put in the serial number.  Once you put the serial number in you need to go back to the Top Zone programming in the CCS and follow the steps in reprogramming the Top Zone.

To activate Top Zone go to page 5-171 in your operators manual and follow the steps, to be able to set your Zones.  After  activating Top Zone in the CCS, you need to go in to teachin-program on your remote and set your degree point. Then you should be able to create your Zones.

Voltage is reading 488 volts.  It’s too much voltage.   Need to reprogram hoist drive per service bulletin.TJF Service Bulletin