Bringing the crane down in maintenance mode for checking the trolley or replacing hoist rope. It is not in the manual to do this. You need to push the escape and the down arrow on the LOGO to bypass all sensors then you will need to jumper the banana bar in the back.n This is jumpering the banana bar moment for trolley and hoist. You also need to either loosen the banana bar senors or unbolt them as it will crush them with the jib tip to the ground. That would also mean they need recalibrated.
From the picture it looks like we are jumpering 26T1 to NC-SLL and NC-SP to 26T1 and removing the blue and white wire out of NC-SLL
How do you jumper the banana bar?
How do you jumper the banana bar in the back?
I updated this but Can Chad Mike or Thaddeus please confirm ?
Yep looks good we did not loosen or move the sensors in the back when we did it with the Italians. They did mention to do that but we did not and it was fine. I think it was him just worrying about bending stuff in the back, but that’s what I remember. Doesn’t mean that we don’t have to loosen them