MDT 219 Jib Identification
Use this to put jib parts together with their fucked up names from Potain
Potain 27148 Trolley stopped working Fault FST
Crane stopped working one morning when the operator doing warm up. Start the crane up and all the drives fire up but trolley immediately goes to FST.
We plugged in the handheld and crane works fine.
Got this from Tomas and he said you should try this if the crane is acting funny and you can’t get figure what it is.
Dusty,
Try this.
Hello Tomas,
We think you have an issue with H335H (green light). This light is connecting on Terminal G-33 (only with remote control ).
Try to disconnect it and work with remote control. Please find in attachment the light part number.
Best regards
Top slew minimum adjustment of moment sensor
All Top slew CCS machines
Don’t worry about the measurements, but make sure the mA’s are dead on.
Hoisting Problem on MDT
Re routed the can bus cable and got it away from all the high voltage incoming cables, brake chopper cable etc
Fault has cleared it self . Crane is picking fine
Going to monitor for a little while longer
It is the 3 wire plug that goes into the faceplate of the drive.
Before/After
Checking Slew bolt Torque
Potain 27148 T85 Electrical Diagram
Potain 27148 T85 Change Rope Reeving to SM1
Threshold for Load on T85
Make sure to be aware of the different password you must enter to get into these settings.
We went as low as we could in California, which was 90%
Layout for Outriggers
T85 and HUP 40/30
14’8″ center to center 20’8 7/8″ Diagonal
HUP 32/27
13′ Center to Center 18′ 4 5/8″ Diagonal
Liebherr 81k.1
14′ 9″ Center to Center 20′ 10 5/16″ Diagonal