The operator called and said the crane would not swing or the trolley have him send a picture of the remote. IT had E 39 on it. Looked it up and found that it was in the forbidden zone. Had to turn key for zoning in the side panel to override the zoning and drive the crane out of the zone then switch the key back to make sure the zoning was back on. 
Mast Maintenance and Repair
Info on Mast Maintenance and repair along with how to shim mast
Figuring out Distance for 90% 110% and 125% for load charts for MR MRH and T85 125%
For 90% take your known load and times by 1.1 and then match up to the load chart
For the others take the number less than 100 and times that by the load. For example for 110% take load times .9 and then match that number on the load chart.
Auto wind on Hoist on T85
Auto wind on hoist while raising and lowering mast not working .
Did trouble shooting with Potain and used these screens to determine if signal was getting to processor and then to drive.
Also screen will show you how much weight on load line while going up was consistent at around 800-1000 lbs going down was around 0-250
We found brake disc on hoist was hanging up just enough to cause the issue. Took apart Hoist brake and cleaned and anti seazed everything and all seems to be working now
Use videos for reference of what should be chaning on outputs when you start to raise the mast IMG_9049
T130 MOUNTING ASSISTANCE MENU
CCS CRANES PRINCIPAL BETWEEN MOTOR ENCODER AND CCS ENCODER
Slewing ring bolts & screws maintenance.
HUP 32/27 Narrow Stance
Potain MDT 109 Cab Rigging
Put 2 – 7/8″ Shackles on the Front of the cab and 3/4″ Shackle on the back and it picks like a dream
Low Maintenance Position For HUP
How to fold out jib on HUP as long as it has new software update when the crane is folded up or axles. Note that support is needed to be able to do this at the end of the first jib section.
Also attached is how to fold out without new software